You are here

avrdude: stk500_getsync() not in sync: resp=0x13

4 posts / 0 new
Last post
#1 Sun, 2016-05-22 13:20  

avrdude: stk500_getsync() not in sync: resp=0x13

nschreiber0813
Offline
Last seen: 8 months 3 weeks ago
Joined: 21 May 2016 - 17:54

Dear: CKR

Just to let you guys know my 3D printer is very close to being finished. I bought a new microcontroller for my 3D printer but I then uploaded bootloader to it twice it worked fine and got the same result. Then I tried uploading the firmware and it seems like the bootloader did nothing. I know the bootloader worked but I can't upload code to it. I am getting that avrdude error. Can I please have some help? Thanks!!!

From: Noah

PS: I am using sanguinololu and atmega1284p. I just bought a new microcontroller from mouser and put bootloader in it. Thanks!!!

Sun, 2016-05-22 14:19  

Com port maybe? here is a video with 3 things to check

Roxanna77
Offline
Last seen: 10 hours 18 min ago
Joined: 21 Sep 2015 - 12:13

Watch this video, might help I hope!

https://www.youtube.com/watch?v=ze_PKgCJoVM

 

 


~Roxy~
"Propeller Girl"
I tinker, therefore I am.....

 

 

Sun, 2016-05-22 14:48  

Well that video didn't explain exactly what my issue is.

(Reply to #2)
nschreiber0813
Offline
Last seen: 8 months 3 weeks ago
Joined: 21 May 2016 - 17:54

Dear: Roxanna 

Just to let you know that is not the issue. I know com 8 on my computer is the right one because there are no other coms. Thanks anyways!!!

from: Noah

I don't know what to say LOL!!!

Wed, 2016-05-25 20:45  

Any luck yet?

Roxanna77
Offline
Last seen: 10 hours 18 min ago
Joined: 21 Sep 2015 - 12:13

any luck on the sanguinololu and atmega1284p board yet?

 

 


~Roxy~
"Propeller Girl"
I tinker, therefore I am.....